CO100/Ar
Conventional carbon monoxide gas sensor. IP66
The CO gas sensor CO100/Ar detects the presence of TOXIC GAS such as Carbon Monoxide. The sensor is fitted with an Electrochemical Cell sensor and is managed by a microprocessor, which not only supplies an alarm signal to the Control Unit connected to it, but also allows execution of self-diagnosis in order to obtain the maximum detection accuracy at any time. This device is useful when both the maximum CO admissible concentration threshold set to 300ppm is exceeded, and when low CO concentrations persist in the environment for lengthy periods, and which according to the principle of accumulation, could also damage the human organism.
Test: to perform a precise and self-certified test, use the TS1008 instrument, which also serves to carry out the annual check.
EN 45544-1-3 – CEI 216-3 – EN 50270
Primary power supply: 12 ÷ 24 VDC ± 10%
Absorption: 1W Max @ 13.8 VDC
Alarm relay: 1 changeover 10 A SELV
Failure relay: 1 ON -OFF 10 A SELV
Detection: Carbon Monoxide
Sensor: Electrochemical Cell
Measuring range: 0 – 5000 ppm
USB test socket: TS1008
Analog output signal: 4 ÷ 20 mA on 220 Ohm
Long-term drift in clean air: <+ 3% ppm
Working temperature: 50 ° C
Container and degree of protection: Aluminum IP66
Dimensions: 100x100x60 mm
The perfect partner for the wholesaler
For years, Beinat is your company’s trusted partner: its products are 100% guaranteed and its reliability allows a constant turnover within your warehouse. The study of our products allows obtaining advanced equipment capable to meet all needs. Our quality certifications and warranty
Our quality and guarantee certifications
The importance of quality policy
The goal has always been to provide products that meet the customer’s needs, through continuous performance improvement and with a full commitment.
