GS300-Mc Toxic and Explosive Gas Detector Control Unit for Industrial use
Cod. GS300-Mc - Toxic and Explosive Gas Detector Control Unit for Industrial use
The GS300-Mc control unit has been designed and built according to European regulations to flexibly detect the presence of toxic and/or explosive gas and Oxigen, through the connection of 3 remote sensors.
Thanks to this and its other features GS300-Mc is suitable for civil use, industrial use and small underground car parks.
The GS300-Mc control unit has three danger levels:
1st LEVEL, 1st Alarm. This was set to 8 % of L.E.L. (120ppm) for all probes.
2nd LEVEL, 2nd Alarm. This was set at 13% of L.E.L. (200ppm) for all probes.
3rd LEVEL, Main Alarm. This was set at 20 % of L.E.L. (300ppm) for all probes.
Other technical features make this control unit extremely versatile and reliable; for example, by using a series of microswitches it is possible to:
Select or disable the probe when not installed or faulty;
Select the type of gas to be detected (toxic or explosive);
Choose the relay functioning mode (pulsed or continuous);
Choose selection of the intrinsic safety
Multicolor Display LCD: Showing the current status of the Unit LCD display with easy to read color one for each operating status
1) Adjust: Green
2) Alarm: Red
3) Fault: Yellow
Power Supply: 110/240 VAC 50/60 Hz.
Battery power supply: 12 VDC ± 10%
Power Demand: 11,3 W during alarms
The Pre alarm Relay: 10A 250V resistive
Main Alarm Relays: 10A 250V resistive
Max number of probe: 3
Catalytic, Pellistor, Electrochemical, Semiconductor
Explosion alarm threshold: 20 % of L.E.L.
Toxic alarm threshold: From 30 ppm to 300ppm
Input signal: 4 ÷ 20 mA
Accuracy: 1 % FS
Multicolor Display LCD: Showing current
Positive Safety: Selectable
Fault output relay ON-OFF
Functioning temperature: -10°C ÷ + 60°C
Functioning humidity : Lower than 90% RH
Degree of protection: IP44
Installation: Wall or panel mounted
Weight: 500 grams about