CIO200/duct ADDRESSED Carbon Monoxide gas sensor for Residential and Tertiary use
Cod. CIO200/duct - ADDRESSED Carbon Monoxide gas sensor for Residential and Tertiary use
The stand-alone CIO200/Duct probe has been designed and built according to the rules of the European legislation for toxic gases in a versatile way to verify the presence of carbon monoxide "CO".
The probe is equipped with an Electrochemical Cell Sensor and is managed by a microprocessor which, in addition to providing an alarm signal to the switching power plants, allows to directly operate the relays it is equipped with when the gas concentration exceeds the predetermined threshold. This probe is useful both when the maximum permissible CO
concentration is exceeded, set at 300ppm, or when long periods of low CO concentrations persist but in the accumulation principle they can also damage the human body.
Test: to perform a precise and self-certified test, use the TS1007 instrument, which also serves to carry out the annual check.
Power supply: 12÷24 VDC ± 10%
Power on demand: 1W max @13,8V
Relay Alarm in change: 10 SELV
Fault Relay: 10 A 250V SELV
Sensor: Electrochemical Cell
Operating range select.: from 0 to 5000ppm
Data transmission signal: RS485 prot. ModBus RTU
Alarm Threshold: 300ppm
Pack and Degree protection: Aluminum IP66
Service Port: Present
Rod size: 200x20 mm
Flange size: 60 mm
Packaging dimensions: 160x120x350
Weight: 760 grammes
Compatible unit: BXI32