BEINAT CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use
  • BEINAT CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use
  • BEINAT CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use
  • BEINAT CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use
  • BEINAT CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use

CO200/duct TOXIC Gas Probe and Control Unit for Industrial use

Cod. CO200/duct - TOXIC Gas Probe and Control Unit for Industrial use


The standalone CO200/duct probe has been developed and manufactured , in order to enable versatile verification of the presence of Carbon Monoxide. The probe is fitted with an Electrochemical Cell sensor and is managed by a microprocessor which not only supplies an alarm signal to the units connected to it, but also can directly drives any kind of externaldevices using its built in relays. This probe is useful when both the maximum CO admissible concentration threshold set to 300 ppm is exceeded, and when low CO concentrations persist in the environment for lengthy periods, and which according to the principle of accumulation, could also damage the human organism. There are two outputs in the probe:
The second output is connected when necessary to detect 4 to 20 mA linearly, but with bottom scale at 300 ppm.

Power Supply: 12÷24 V. dc ± 10%
Power Demand : 1 W max @13,8V
The Pre alarm Relay: 10A SELV
Main Alarm Fault: 10A SELV
Sensor and Protection: Electrochemical Cell,
Range of Measurement: 0 to 1000ppm
Toxic alarm threshold: From 30 to 300ppm
Output Signal: 4 ÷ 20 mA
Data transmission: Not present
Service Port: Present
Test Phase Duration: 90 seconds
Functioning Temperature: -20°C to +50°C
Degree of Protection: Case IP65
Compatible control units: whole range
Case and size: Aluninium -100x100x60
Rod Size: 200x20 mm
Flange Size: 60 mm
Packaging: 197x122x67
Weight: 300 grams about


PDF Download pdf file


VIDEO VIDEO TUTORIAL: CONNECTIONS

CO200-duct_installation »

Probes - Control - Test »

CO200/duct