BX180 Toxic and Explosive Gas Detector Control Unit for Industrial use
Cod. BX180 - Toxic and Explosive Gas Detector Control Unit for Industrial use
Through the connection of 1 remote probe, the BX180 control unit has been designed and built according to European regulations to detect the presence of toxic and/ or explosive gas flexibly.
A microprocessor is used to create a complete surveillance and control system with maximum flexibility. Thanks to this and its other features, the BX180 is suitable for civil and industrial applications.
The BX180 control unit has two danger levels:
1st LEVEL, 1st Pre-Alarm. This was set at 13 % of L.E.L. for all probes.
2nd LEVEL, Main Alarm. This was set at 20% of L.E.L.
Other technical features make this control unit extremely versatile and reliable; for example, by using a series of micro-switches it is possible to:
Select or disable the probe when not installed or faulty;
Select the type of gas to be detected (toxic or explosive);
Choose the relay functioning mode (pulsed or continuous);
Choose selection of the intrinsic safety.
Power Supply: 110/240 VAC 50/60 Hz.
Battery power supply: 12 VDC ± 10%
Power Demand: 5W during alarms
The Pre alarm Relay: 10A 250V resistive
Main Alarm Relays: 10A 250V resistive
Max number of probe: 1
Catalytic, Pellistor, Electrochemical, Semiconductor
Explosion alarm threshold: At 20 % of L.E.L.
Toxic alarm threshold: From 30 ppm to 300ppm
Input signal: 4 ÷ 20 mA
Accuracy: 1 % FS
Positive Safety: Selectable
Fault output relay ON - OFF
Functioning temperature: -10°C ÷ + 60°C
Functioning humidity : Lower than 90% RH
Degree of protection: IP20
Installation: Panel mounted
Size: 105x90x58 6 modules
Weight: 250 grams about